poyserious.blogg.se - How to use macrium reflect to upgrade ssd

#How to use macrium reflect to upgrade ssd how to#
#How to use macrium reflect to upgrade ssd install#
#How to use macrium reflect to upgrade ssd driver#

If the MBR partition type is in use -> Make sure the computer use the Legacy boot method.

That said, make sure you set the boot type in BIOS accordingly, as follows: Whichever partition type your old SATA drive uses, the new NVMe drive will use that, too.

The computer won’t boot successfully, showing boot error like “Boot drive not found” or a blue screen.

Or remove the old SATA drive if you don’t want to bother with the BIOS.

The computer keeps booting into the old SATA drive: Make sure you change the boot order to make the NVMe SSD the first boot drive.

#How to use macrium reflect to upgrade ssd how to#

I didn’t run into any issues, but here are the common few and how to fix them. In this case, you’ll likely need to re-activate the software (Windows, Office, etc.).

In this case, make sure the new one uses the same boot method - BIOS or UEFI - as the old one.

#How to use macrium reflect to upgrade ssd install#

In my case, the machine now booted up in about 5 seconds, down from almost 20 seconds.Īlternatively, you can also install a newly cloned NVMe SSD into another computer. Most new motherboards have an M.2 slot and, therefore, are for an NVMe SSD upgrade.Īnd that’s it! Now, you’ll notice a significant performance improvement, even if your old SATA drive is an SSD. You can get to the BIOS by tapping on the F2 or Delete key on the keyboard right after pressing on the power button to turn the machine on most computers. You can do this by going to the Boot section of your computer BIOS.

Change the boot order of your computer to boot from the NVMe drive first.

Remove your SATA drive and mission accomplished! If you want to keep the SATA drive in your computer as a secondary drive, continue to step #6.

Once the cloning process is complete, turn your computer off. (For details on cloning using Macrium Reflect, check out this post.) When you’re at it, note if your current SATA drive uses an MBR or GPT partition for later troubleshooting.

Run the drive cloning software and clone the existing SATA drive to the NVMe drive.

After the installation, restart your computer.

#How to use macrium reflect to upgrade ssd driver#

For older Windows, download and install the NVMe driver software for your SSD. If you’re using Windows 10, skip to step #4.Install Macrium Reflect (or any drive cloning software that you’re comfortable with).It will boot into the SATA drive as it did before. Assemble the NVMe drive onto your computer using the M.2 slot or the PCIe slot (via an adapter). Make sure your computer is turned off.Windows in-place NVMe SSD Upgrade: Steps by steps I recommend the free version of Macrium Reflect. An NVMe PCIe adapter, only if your computer doesn’t have an NVMe M.2 slot.For example, if you’re using a 1TB SATA drive that’s 30 percent full, a 500GB NVMe drive (or larger) will do. An NVMe solid-state drive: Get a drive of a significantly larger capacity than the total data on the SATA drive.You can use a desktop’s graphics PCIe slot for an NVMe SSD upgrade